Dacor 24GN Installation Instructions, If the unit is to be connected directly to the house wiring

Installation Instructions

Electrical Connection

(Continued)

13.Feed the electric wire or cord into the utility hole in the side of the cut-out. Pull all of the slack out of the wire.

If the unit is to be connected directly to the house wiring:

•With power turned off at the circuit breaker or fuse box, remove the house junction box cover.

•Feed the dishwasher wiring into the junction box. Secure the wire with a UL/CSA approved strain relief.

•Strip and connect the wires according to one of the wiring diagrams below.

•Tighten the strain relief. Check to make sure the wire is secure.

•Replace the junction box cover and screws.

Utility Cut-outs
Hoses	Wire or
	cord

warning
• Connect the dishwasher ground wire to a separate,
properly grounded wire installed by a licensed	Feed the electric cord (or wire) and both hoses into the
electrician.
	utility cut-out(s); direction varies with installation.

•A grounded cold water pipe must have metal continuity to an electrical ground and must not be interrupted by insulating materials. Any insulating

materials must be jumped with a length of No. 4		To house circuit breaker
copper wire securely clamped to bare metal at both			panel or fuse box
ends. See diagram below.
				Separate No. 10 (minimum)
To house circuit breaker
	Junction box			copper ground wire
panel or fuse box

Wire nut,
3 places		WHITE		WHITE		Fasten clamp tightly
		WHITE
				WHITE		on pipe
	GREEN
		BLACK	GREEN	BLACK	Wire nut,
	GREEN		GREEN
		BLACK		BLACK
					3 places
						Meter
						No. 4
					copper wire

Strain relief		Junction box	Strain relief
To dishwasher			To dishwasher
	Standard 3-Wire Connection			3-Wire Connection		Clamps
	to House Junction Box*			with External Ground*
						Bare metal
	* Does not apply when using a 3-Prong power cord.				Insulated Pipe Jumper
						(if necessary)

8