Operating Your Dishwasher
The Cycle Memory Feature
Your dishwasher remembers the settings for the last cycle it ran.
If you want your dishwasher to run the same cycle as it ran the previous time:
1. Press the START/STOP button once. |
| |
START | ||
| ||
The START/STOP button light will flash and the lights on the | STOP | |
buttons for last cycle and options run will be lit. |
|
2.Press the START/STOP button again to run the previous cycle (or you may select a different cycle, then press START/STOP if you don’t want to run the previous cycle).
START
STOP
3. Close the door. After a short pause, the dishwasher will begin to operate.
If the delay feature was used during the previous cycle, your dishwasher will start after the number of hours originally selected.
Draining Standing Water
To drain standing water from the bottom of your dishwasher: 1. Press NORMAL.
|
| NORMAL | |
2. | Press START/STOP. | START | |
|
| STOP | |
3. | Press CANCEL. | CANCEL | |
4. | Close the door. After a short pause, you will hear the | ||
|
water in the dishwasher begin to drain. Once the water is drained, the dishwasher will stop.
IMPORTANT: Your dishwasher also drains the water at the bottom at the start of each wash and rinse cycle.
The SECURE Feature
To secure the control panel: |
| |
1. Press and hold the SECURE button down for 3 |
| |
SECURE | ||
seconds. All control panel lights are deactivated and | ||
none of the buttons operate. |
| |
|
2.To turn off the secure feature, press and hold the SECURE button down for 3 seconds.
The control panel beeps when you turn this feature on and off.
Use and Care Manual | 19 |
|
|
