Dacor 65537 manual Problem Solution Guide continued, Problem Solving, Dishwasher, May be caused by

Problem Solving

Problem Solution Guide (continued)

Problem:	May be caused by:	What to do:
Chipping or breaking	Improper loading	Do not overload. Load between rack prongs, not
of glassware		over them. Glasses loaded over prongs will not be
		supported and may chip or break. Make sure
		glassware is secure and can't come loose. Always
		use the top rack for delicate items. Use the crystal
		cycle for china.
Unusual noise	Improper loading	Utensils may not be secure or something small may
		have dropped from the rack. Water may cause
		utensils to rattle. Make sure dishware is secure.
Water left in bottom	Dishwashing cycle not complete	Allow dishwasher to complete cycle.
of dishwasher near	CANCEL button pressed twice in middle	Restart (page 16) or drain (page 19) dishwasher.
filters	of cycle.
	Some water is normal	Water left in strainer is normal.
Dishwasher will not	Air gap plugged	Be sure the air gap is not blocked or plugged. The
drain		air gap is a vent located on top of the sink. It is
		connected to the dishwasher. It is required by some
		local codes.
	Drain hose	Check for kink in drain hose.
	Filter system	Be sure there is no blockage in filter system.
Dishwasher will not	Blown fuse or tripped circuit breaker	Replace fuse or reset circuit breaker. Remove other
start		appliances from the circuit.
	Door not completely closed	Push in on door handle until you hear a click.
	Not plugged in incorrectly	Make sure plug is inserted in the wall socket or
		dishwasher is wired correctly.
Dishwasher will not	Door not completely closed	Push in on door handle until you hear a click.
fill	Controls not set	Make sure dishwasher is on (see Page 16).
	Water feed line blocked	Make sure water feed line to dishwasher is not
		kinked.
	No water supply	Make sure water valve is turned on.
Water backs up in	Garbage disposal or sink trap full	Run garbage disposal to eliminate food and
sink when		obstructions in sink. Make sure sink drains properly.
dishwasher drains
Marks and	Aluminum utensils rubbing against items	Be sure aluminum utensils, especially light weight,
discoloration	during wash cycle	foil-type pans, do not touch dishes.
Yellow or brown	Iron or manganese in water	To remove spots, use a non-abrasive cleaner.
marks		Temporary solution:
		Pour teaspoon to tablespoon of citric acid crystals in
		place of the pre-wash detergent in the detergent
		dispenser. Follow this pre-wash with a full detergent
		wash. Use the heavy wash program.
		Permanent solution: Install an iron removal system
		in the water supply.

26 Dishwasher