Refrigerator Operation
Water and Ice Dispenser
IMPORTANT:
After connecting the refrigerator to a water source, flush the water system. Press the Water touch pad on the control panel. Use a sturdy container to depress and hold the dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) for an additional 5 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.
NOTE: After 5 minutes of continuous dispensing, the dispenser will stop dispensing water to avoid flooding. To continue dispensing, remove the container and press the dispensing lever again.
Allow 24 hours for the refrigerator to cool down and chill water. Dispense enough water every week to maintain a fresh supply.
Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.
Dispenser Operation
WARNING
Dispenser Light
NOTES:
The dispenser lights are LEDs which should not need to be changed.
When you use the dispenser, the lever will automatically turn the light on. If you want the light to be on continuously, you may choose either On or Auto.
AUTO: The light sensor monitors the | AUTO | ON |
light level in the room. The dispenser | ||
light will illuminate at |
|
|
the light level is low. To activate the |
|
|
Auto option press the Light touch pad. |
|
|
The Auto indicator light will illuminate. |
|
|
ON: For continuous light, press the Light touch pad a second time. The On indicator light will illuminate.
OFF: To turn the dispenser light off, press the Light touch pad a third time.
Dispenser Lock
The dispenser can be locked for easy cleaning or to avoid unintentional dispensing by small children and pets.
NOTE: The dispenser lock does not shut off power to the product, to the ice maker, or to the dispenser light. It just deactivates the dispenser lever.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
The dispenser will dispense either water or cubed ice.
NOTE: The DISPENSE WATER control allows you to fill containers that will not fit within the dispenser area, such as sport bottles.
1.Select either water or cubed ice by touching the Water or Ice pad on the control panel. The light above the control indicates your selection.
To Lock and Unlock Dispenser:
1.Press and hold the LOCKED touch pad for three seconds to lock the dispenser. The indicator light will illuminate when Lock is on.
2.Press and hold the LOCKED touch pad again for three seconds to unlock dispenser. The indicator light will turn off.
LOCKED
PRESS 3 SEC
DISPENSE
WATER
Water | Ice |
2.Press a sturdy container against the dispenser lever.
IMPORTANT: You do not need to apply a lot of pressure to the lever in order to activate the dispenser. Pressing hard will not make the water or ice dispense faster or in greater quantities.
3.Remove the container to stop dispensing.
8
