Dacor EF36LNBSS Custom Panel and Handle Installation IF36 Series Models, Door Panel Installation

Installation Instructions

Custom Panel and Handle Installation - IF36 Series Models

IMPORTANT:

ƒƒ Install the custom handles prior to installing the panels on the refrigerator.

ƒƒ Create custom door overlay panels according to the specifications in the Custom Panels and Handles section.

ƒƒ Dacor is not responsible for customer installed molding or decorative panels that need to be removed or replaced to service the refrigerator.

3. Remove the	A
trims and
corner caps.
	B

Handle Installation

Before installing a custom panel assembly, install the custom handle hardware.

Counter-sink the screw head into the back of the panel to allow the panel to slide into place smoothly and for proper fit.

C

B

A

A

A

A. Countersunk screw

B. HandleC

C. Door panel assembly

Side View

Front View

Door Panel Installation

1.Remove all tape and door bracing from the refrigerator and freezer doors.

2.Open the refrigerator and freezer compartment doors.

4.Slide the custom panels into the bottom and hinge side trims

on the refrigerator compartment and freezer D compartment doors, making sure that the backer panel fits into the hinge side trims.

5.Reinstall the trims and corner caps.

A. Corner caps

B. Refrigerator door trims C. Freezer drawer trim

D

D. Panels

6.Remove the protective skin from the screw covers. Slide or snap the screw covers into the handle trim section.

7.Check refrigerator level

and alignment. Adjust if needed.

Continued...

17