Dacor IF36LNBOL Adjust Doors, Custom Panel Installation IF36 Series Models, Top Grille Panel

Installation Instructions

Custom Panel Installation - IF36 Series Models (Continued)

Top Grille Panel

1.Grasp both ends of the top grille.

2.Push straight up, then pull straight out. Place the top grille panel-side down on a soft working surface.

BAB

A. Top grille

B. Cabinet side trim

3.Remove one end cap by loosening the nuts and sliding the end cap off.

	C
F	D
E
C. Bottom rail		E. End cap
D. Nuts		F. Top rail

4.Slide the custom panel into the top grille channel and reattach the end cap.

G

G. Custom panel

5. Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.

Adjust Doors

Door Swing Adjustment

1.Check that the refrigerator door can open freely. If the door opens too wide, remove the door stop screw or screws (depending on your model) from the bottom hinge with a Torx T15 screwdriver.

2.Hold the door open to a position that is less than 90°.

3.Replace the door stop screw or screws in the bottom hinge and tighten.

A.Door stop screw

A

B C D

B. 130° position

C. 110° position (IF series refrigerators)

D. 90° position

IMPORTANT: Do not place the door stop screw in the 130° position on IF Series models. See “Handle and Door Clearances.”

Door-to-Door or Door-to-Refrigerator Trim Adjustment

1.Loosen, but do not remove, the four Torx 27 flat-head mounting screws and the two ¼” hex head mounting screws.

2.Adjust the top hinge of either door to align it with the other door or the refrigerator trim.

3.Tighten the four Torx 27 flat-head mounting screws to a torque of approximately 100 inch-pounds (11.3 Nm) and tighten the two ¼” hex head mounting screws.

A

B

A.Torx 27 flat-head mounting screws

B.¹⁄4 " hex-head mounting screws

18