Before You Call for Service
Problem | may be caused by | What to do | |
Small particles deposited on | Incorrect detergent use | Use only correct amount of dishwasher detergent according | |
items (cont.) |
| to water hardness (see page xx) and the wash program | |
|
| selected. Fill dispenser only when ready to start the | |
|
| dishwasher. Do not use old or caked detergent. Store | |
|
| dishwasher detergent in dry place and in a closed container. | |
|
| Change the dishwasher detergent if results are still poor. | |
| Filter system | Make sure filter system is clean and properly installed. | |
| Low water pressure | Check that water valve is fully open. Make sure water | |
|
| pressure is between 20 and 120psi and flow rate is 1.0 gpm | |
|
| minimum. | |
| Water not hot enough | Check hot water supply temperature. Minimum | |
|
| recommended incoming temperature to the dishwasher is | |
|
| 120ºF. | |
| Items not loaded properly or | Make sure dishwasher is loaded according to instructions | |
| overloaded | (see page xx). Do not overload. Make sure spray can reach | |
|
| all soiled surfaces. | |
| Incorrect wash cycle selected | Select a wash cycle with a longer wash time. | |
|
|
| |
| Hard water | See “Hard water” under Spotting and filming on page xx. | |
|
|
| |
Detergent left in detergent | Detergent dispenser lid not | The lid may not be opening. Check for items blocking it. | |
compartment | opening |
| |
| Old detergent | Do not use detergent that is hard or caked in the box. Use | |
|
| only fresh detergent. Add detergent to dishwasher just | |
|
| before starting it. | |
| Spray arms do not rotate properly | Make sure that both spray arms rotate freely. Make sure that | |
|
| items do not obstruct movement of spray arms. If necessary, | |
|
| clear any obstructions. Make sure top rack is pushed in all | |
|
| the way so that spray arm on rack connects to nozzle on | |
|
| back wall. | |
|
| Make sure holes in spray arms are not blocked. If | |
|
| necessary, clear holes with a pointed object and rinse under | |
|
| water. | |
| Cycle not complete | Close door, wait for cycle to complete. | |
|
|
| |
Chipping or breaking of | Improper loading | Do not overload. Load between rack prongs, not over them. | |
glassware |
| Glasses loaded over prongs will not be supported and may | |
|
| chip or break. Always use the top rack for delicate items. | |
|
| Dacor recommends that you wash fine china and crystal by | |
|
| hand. | |
Unusual noise | Improper loading | Utensils may not be secure or something small may have | |
|
| dropped from the rack. Water may cause utensils to rattle. | |
|
| Make sure dishware is secure. | |
Water in bottom of dishwasher | Dishwashing cycle not complete | Close door. Allow cycle to finish. | |
tub near filters. |
|
| |
Some water in strainer is normal | Some water in strainer portion of filter at end of cycle is | ||
| |||
|
| normal. | |
| See “Dishwasher does not drain |
| |
| Properly” below |
| |
Dishwasher does not drain | Air gap plugged | Be sure the air gap is not blocked or plugged. The air gap | |
Properly |
| is a vent located on top of the sink. It is connected to the | |
|
| dishwasher. It is required by some local codes. | |
| Drain hose kinked | Check drain hoses. Make sure they are not kinked. | |
| Filter(s) clogged | Check and clean filter(s) if necessary. See page xx. |
20