Installation Instructions

Electrical Connection (cont.)

Connecting the Conduit to the House Electrical Junction Box

warning

•Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit.

•Do not ground the appliance to a gas supply pipe or hot water pipe.

•A grounded cold water pipe must have metal continuity to electrical ground and must not be interrupted by insulating materials. Any insulating materials must be jumped with a length of No. 4 copper wire securely clamped to bare metal at both ends. See below.

No. 4

copper wire

Meter or other

insulating device

Metal

water pipe

Clamps

Bare metal

Insulated Pipe Jumper

1.With the range positioned directly in front of the cabinet cutout, feed the appliance wires into the junction box. Depending upon local codes, utilize one of the three (3) methods shown to connect the appliance inside the junction box.

2.Connect the white wire from the appliance to the neutral (white) supply wire inside the junction box.

3.Connect the black wire from the appliance to the black (L1) power supply wire inside the junction box.

4.Connect the red wire from the appliance to the red (L2) power supply wire inside the junction box.

5.If using a 4-wire connection, connect the green wire to a grounded supply wire in the junction box or to a grounded cold water pipe. If connecting to a grounded cold water pipe, use a separate copper grounding wire (No. 10 minimum) to connect to the cold water pipe by means of a clamp and an external grounding connector screw.

6.Replace the junction box cover.

Connection to house

power supply

Junction box

Wire nut 4 places

RED WHITE

RED WHITE

GREEN BLACK

GREEN BLACK

Conduit to appliance

4-Wire Conduit-Junction Box Connection

12