SETUP
Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your Projection Monitor for at least 20 minutes before using this feature.
2.Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.
3.If Auto Adjust mode is selected or the Magic Focus button is pressed, all manual adjust mode settings will be erased.
Using the Remote Control, select
To Move Adjustment Point
To move the adjustment point cursor using the CURSOR buttons, the Adjustment Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white.
MENU
Video
Audio
Aspect
Locks
Setup
Move SEL Sel
Setup
Magic Focus Tune Up
Aligns the Red, Green, and Blue colors to correct for Magnetic Influences.
Adjustment Mode
Auto
Manual
If you want to adjust now 
Start
SELECT
SELECT
SELECT
Setup
Magic Focus Tune Up
Menu Preference
Set The Clock
Set The Inputs
Set The Color System
Set Virtual HD
Set Black Side Panel
Set Closed Captions
About Your TV
Move SEL Select
Adjustment Point
Cursor
Move SEL Return
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
117 Manual Adjust
Please Enter Number.
0.Cancel and go to Normal Mode.
1.Done and go to Normal Mode.
EXIT
2.Back to Adjust Mode
3.Factory Reset and back to Adjust Mode.
Press the [0] button on the remote control to CANCEL adjusted data and return to main picture. Press the [1] button on the remote control to SAVE adjusted data and return to main picture.
Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern). Press the [3] button on the remote control to recall the factory
47
