0817DTBD-LN11PA-AGN(GB) 2006.8.17 4:8 AM ˘ ` 17

Connectionsti

•There are a variety of ways to connect the DVB-T DVD Recorder to your TV and other equipment. Use only one of the connections described below. Whichever TV connection you use will work with all input sources.

•Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best connections.

•For better sound reproduction, connect the DVB-T DVD Recorder’s AUDIO OUT jacks to the audio in jacks of your amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 18.

Caution

•Make sure the DVB-T DVD Recorder is connected directly to the TV, and the TV is set to the correct video input.

•Do not connect the DVB-T DVD Recorder’s AUDIO OUT jack to the phone in jack (record deck) of your audio system.

•Do not connect the DVB-T DVD Recorder via your VCR. The DVD image could be distorted by the copy protection system.

If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the rear panel of the DVB-T DVD Recorder.

Use the supplied RF cable to connect between the DVB-T DVD Recorder’s OUT (TO TV) jack and the antenna input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all cable channels).

Connecting a TV

Choose one of the following TV connections, depending on the capabilities of your equipment.

Rear of TV

S-VIDEO

COMPONENT/PROGRESSIVE VIDEO INPUT

 

ANTENNA

INPUT

 

 

 

 

INPUT

 

Pr

Pb

Y

 

 

S

C

 

 

V

R

CONNECTIONS INTRODUCTION

Connecting Antenna/Cable

1Disconnect the antenna/cable from the rear of your TV.

2Connect this cable to the jack marked ANT IN (FROM ANT.) on the rear panel of the DVB-T DVD Recorder.

Antenna Antenna

TV

VCR/DVD

Rear of DVB-T DVD Recorder

RF Connection

Connect the ANT OUT (TO TV) jack on the DVB-T

Flat Wire (300ohm)

Cable TV Wall Jack

DVD Recorder to the antenna in jack on your TV using the supplied 75-ohm RF cable (R).

300/75ohm Adapter

OR

OR

(Not supplied)

TV

VCR/DVD

Rear of DVB-T DVD Recorder

This set doesn’t have a modulator output. However it still applies the RF through Output.

Scart Connection

1Plug a scart cable into the scart socket TV (EURO AV1) at the back of the DVB-T DVD Recorder and the corresponding scart socket at the back of the TV set. (V)

2Plug a scart cable into the blue scart socket VCR/DVD (EURO AV2/DECODER) at the back of the DVB-T DVD Recorder and the corresponding scart socket at the back of the Decoder.

17