Troubleshooting
Symptom | Cause | Solution |
Cannot record or did not | The remaining blank space on the |
record successfully. | disc is insufficient. |
| The source you are trying to record is |
| |
| When setting the recording channel, |
| the channel is tuned on your TV’s |
Timer Recording not | tuner. |
Clock in | |
possible. | set to correct time. |
| Timer has been programmed |
| incorrectly. |
| TIMER indicator light does not appear |
Stereo Audio Record | after programming timer. |
TV is not | |
and/or Playback not | Broadcast program is not in stereo |
present. | format. |
| |
| are not connected to TV A/V In jacks. |
| |
| is not selected for viewing at the TV. |
Remote control does not | The remote control is not pointed at |
work properly. | the remote sensor of the |
| Recorder. |
Use another disc.
You cannot record the source.
Select the channel on the
Set clock to correct time. See ‘Set Clock‘ on page 27.
Reprogram Timer. See ‘Timer Recording‘ on page 43~45.
Reprogram Timer.
No solution.
No solution.
Make A/V connections. Stereo is available only via A/V output from
Select AUX or A/V source as TV input.
Point the remote control at the remote sensor of the
The remote control is too far from the
There is an obstacle in the path of the remote control and the
The batteries in the remote control are dead.
Operate the remote control within 23 ft (7m).
Remove the obstacle.
Replace the batteries.
RESET : If the set is in malfunctions, unplug the power cord, and then plug it in after 5 seconds. As this set is a Digital Multimedia Product, malfunction may occur.
Moisture Condensation
Moisture condensation can occur: | In locations where moisture condensation may occur: |
When the
Under extremely humid conditions.
Keep the
When condensation has occurred, wait a few hours for the
52