Using Direct button on the remote control
1You can also change the Audio Mode setting with the remote control. Press the MTS button on the remote control to select Audio Mode.
2Use this button to select the Stereo, Mono or SAP.
Present Broadcast | Your Selection | Speaker Out |
MONO | Stereo | Mono |
|
|
|
MONO | SAP | Mono |
|
|
|
STEREO | SAP | Mono |
|
|
|
STEREO and SAP | Stereo | Stereo |
|
|
|
STEREO and SAP | SAP | SAP |
Note
If a broadcast signal is weak, it may cause noise and hum in stereo sound. Please select the Mono mode, the noise and hum should be reduced.
Adjusting the Bass
1With the TV turned on, press the MENU button until “Audio” menu will be displayed.
2Use the WCHV buttons select “Bass” item.
3Press the CVOL button to decrease the bass volume.
4Press the VOLB button to increase the bass volume.
5To return to normal TV viewing, press DISPLAY button or MENU button, or wait 20 seconds.
6Your setting will remain intact until you change it. Your TV will then automatically reproduce either stereo or monaural sound, whichever is broadcast.
1
Audio |
Audio Mode: | Mono |
Bass |
|
| |
Treble |
|
| |
Balance |
|
| |
Surround Effect: | Off |
2
Audio |
Audio Mode: | Mono |
Bass |
|
| |
Treble |
|
| |
Balance |
|
| |
Surround Effect: | Off |
Select | Adjust | Exit |
Select | Adjust | Exit |
3
Audio |
Audio Mode: | Mono | ||
Bass |
|
|
|
|
|
| |
Treble |
|
|
|
|
|
| |
Balance |
|
|
|
|
|
| |
Surround Effect: | Off | ||
4
Audio |
Audio Mode: | Mono |
| |
Bass |
|
|
|
|
|
| |
Treble |
|
|
|
|
|
| |
Balance |
|
|
|
|
|
| |
Surround Effect: | Off |
| |
Select | Adjust | Exit |
Select | Adjust | Exit |
26 Chapter 6 : Adjusting the Sound
