◆If you are using an A/V cable, select the AV input on the TV to see the picture from the video.
◆If you are not using an A/V cable, select the button number on the TV reserved for video input to see the picture from the video.
CONN
E
CTIONS
a n d 
c
o p y i n g
To the TV via antenna cable (if you are not using an A/V cable)
If you are not using an A/V cable, your video can transmit pictures and sound to the TV via the coax aerial cable. Just tune the TV to the video's transmitting channel (factory set to UHF CH 60). Tune the TV carefully to ensure the best pictures and sound.
OK
3 sec.
MENU
PR
OK
PR
OK
Once you have carried out the steps in "Connecting up the video recorder" (page 4), switch on your TV.
Press the OK button of the video’s remote control longer than 3 seconds to call the video´s test picture.
Tune the TV to the test picture using the channel
When you have found the test picture, store it under the button number on your TV for video input.
Press the OK button of the video`s remote control again longer than 3 seconds to release the test picture.
If the quality of the test picture transmitted to the TV is poor due to interference caused by a station transmitting on channel 60, you can tune the video to a different transmitting channel. Find a free channel between 22 and 69 on your TV.
1 2 3
4 5 6
7 8 9
0/
OK
MENU
RF OUTPUT SET
PR 60
OK:confirm MENU:end
Call the video’s "MAIN MENU" choose "VCR Setup" then "RF Output Set".
Type in the free channel.
Store and exit.
◆If the quality of the test picture transmitted to the TV is poor,
17
