Daewoo KOG-8755 manual Earthing Instructions, Installation, Steady, flat location, Power supply

EARTHING INSTRUCTIONS

This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk of electric shock by providing an escape wire for the electric currrent. This appliance is equipped with a cord having a earthing wire with a earthing plug. The plug must be plugged into an outlet that is properly installed and earthed.

WARNING -Improper use of the earthing plug can result in a risk of electric shock.

Consult a qualified electrician or serviceman if the earthing instructions are not completely understood, or if the doubt exists as to whether the appliances is properly earthed.

If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade earthing plug, and a 3-slot receptacle that will accept the plug on the appliance. The marked rating of the extension cord should be equal to or greater than the electrical rating of the appliance.

INSTALLATION

1	Steady, flat location
	This oven should be set on a steady, flat surface.-This oven is designed for counter top use only.
2	Leave space behind and side
	Keep the oven at least 5cm(2 in.) away from both side-walls and 20cm(8 in.) away from rear wall to ensure the correct
	ventilation.
3	Away from radio and TV sets
	Poor television reception and radio interference may result if the oven is located close to a TV, Radio antenna, feeder
	and so on.
	Position the oven as far from them as possible.
4	Away from heating appliances and water taps
	Keep the oven away from hot air, steam or splash when choosing a place to position it, or the insulation might be
	adversely affected and breakdowns occur.
5	Power supply
	• Check your local power source. This oven requires a current of approximately 12 amperes, 230V 50Hz.
	• Power supply cord is about 1.6 meters long.
	• The voltage used must be the same as specified on this oven. Using a higher voltage may result in a fire or other
	accident causing oven damage. Using low voltage will cause slow cooking. We are not responsible for damage
	resulting from use of this oven with a voltage of ampere fuse other than those specified.
	• Should the cable need changing this must be performed by SERVICE MAN as a special cable must be used.
6	Examine the oven after unpacking for any damage such as:
	A misaligned door, Broken door, A dent in cavity. If any of the above are visible, DO NOT INSTALL, and notify dealer
	immediately.
7	Do not operate the oven if it is colder than room temperature.
	(This may occur during delivery in cold weather.) Allow the oven to become room temperature before operating.
8	The minimum height of free space necessary above the top surface of the oven is 100mm.

4