4.Method to reduce the gap between the door seal and the oven front surface.
(1)To reduce gap located on part ‘A’
•Loosen the screw on stopper hinge top, and then push the door to contact the door seal to oven front surface.
•Tighten a screw.
(2)To reduce gap located on part ‘B’
•Loosen two screws on stopper hinge under, and then push the door to contact the door seal to oven front surface.
•Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm2.
11
