Manuals / Daewoo / Kitchen Appliance / Microwave Oven

Daewoo Microwave Oven, KOR-6N575S service manual To remove cabinet, To remove door assembly

Models: KOR-6N575S Microwave Oven

1 26

Download 26 pages 12.42 Kb

Page 10

Image 10

1.To remove cabinet

1)Remove three screws on cabinet back.

2)Pull the cabinet backward.

2.To remove door assembly

1)Remove the screw which secure the stopper hinge top.

2)Remove the door assembly from top plate of cavity.

3)Reverse the above for reassembly.

NOTE : After replacing the door assembly, perform a check of correct alignment with the hinge and cavity front plate.

Page 10

Image 10

Daewoo Microwave Oven To remove cabinet, To remove door assembly, Remove the screw which secure the stopper hinge top

Contents

July Microwave OvenModel KOR-6N575S S/M No. R6N575S001TABLE OF CONTENTS 2. FOR SAFE SERVICE PROCEDURES SAFETY AND PRECAUTIONS1. FOR SAFE OPERATION KOR-6N575S SPECIFICATIONSSPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE 1. OUTER DIMENSION EXTERNAL VIEW1. Safety interlock system 2. FEATURE DIAGRAM4. Oven cavity 7. Do not operate the oven if it is colder than room temperature INSTALLATION5. Power supply 1. Steady, flat locationOPERATIONS AND FUNCTIONS Variable power cookingVariable power setting Approximate PercentageDISASSEMBLY AND ASSEMBLY Cautions to be observed when troubleshooting2 Remove the door assembly from top plate of cavity 2. To remove door assembly1. To remove cabinet 3 Reverse the above for reassemblyPART CODE 3. To remove door partsREF NO PART NAME1 To reduce gap located on part ‘A’ 5. To remove control panel parts PART CODEMetallic gasket plate High voltage circuit wiring 7. To remove magnetron6. To remove high voltage capacitor Magnetron antenna8. To remove wind guide assembly 9. To remove H.V.transformerINTERLOCK MECHANISM AND ADJUSTMENT ADJUSTMENTTROUBLESHOOTING GUIDE TROUBLE 1 Door shut, timer set, but no cooking takes placebe used to check the normal direction resistance of NO ContinuityMeter with 600V or higher voltage Meger should Check the isolation of filament winding of high voltage transformerPROCEDURE 1. MEASUREMENT OF THE MICROWAVE POWER OUTPUTMEASUREMENT AND TEST PROCEDURES 2. MICROWAVE RADIATION TEST2. High voltage capacitor 3. COMPONENT TEST PROCEDURE1. High voltage transformer 3. High voltage diodeWIRING DIAGRAM Refer to Disassembly and assembly EXPLODED VIEW AND PARTS LIST1. DOOR ASSEMBLY 3. TOTAL ASSEMBLYPART NAME NAMEPART CODE DESCRIPTIONPRINTED DATE July DAEWOO ELECTRONICS CORPS/M NO 686, AHYEON-DONG MAPO-GU SEOUL, KOREA C.P.O. BOX 8003 SEOUL, KOREAABOUT THIS MANUAL