Daewoo SD-2100P, SD-8100P owner manual Recording Cassettes, TimerrecordingusingVideoPlus

DV6T711P-AP(DESUK)1 02.7.24 11:17 AM ˘ ` 36 mac001 300DPI 120LPI

Recording Cassettes

■For timer recordings, clock, date, and stations must be set correctly.

■Load a cassette with its safety tab in place and with sufficient free space for the recording.

TimerrecordingusingVideoPlus

1	Call the VideoPlus menu.
	From your TV magazine, type in the number next to
	the programme you want to record ...
	... and confirm.
2	Decide if you want to record "ONCE", "WEEKLY" or
	"DAILY"...
	... and confirm.
3	If you wish to make changes:
	Move to the position you want to change using the
	[< / >] buttons.
	Change the setting using the [< / >] or [number]
	buttons. If all setting are ok, press [OK], till you see
	“OK: CONFIRM” in the bottom line.
	Confirm.

Switch your player off.

CHECK UP!

VIDEOPLUS

83077----

0-9:VIDEOPLUS NUMBER < :CORRECT

OK:CONFIRM SETUP:END

HOW OFTEN DO YOU WANT TO RECORD THIS PROGRAM?

ONCE WEEKLY(ONCE A WEEK) DAILY(MON-FRI) DAILY(MON-SAT) DAILY(MON-SUN)

PR+/-:SELECT

OK:CONFIRM SETUP:END

TIMER PROGRAM (ONCE)

PR	03
START TIME	21:20
END TIME	22:20
START DATE	14/03(THU)
TAPE SPEED	SP
PDC/VPS	ON
PR+/-:SELECT (AV1/AV2)
0-9 : SETUP (PR)
</>:CORRECT
OK:CONFIRM	SETUP:END

•PDC is a service provided by some stations to enable you to perform timer recordings precisely even if the broadcaster delays the start time of the programme slightly. The time you enter is the PDC time so must be correct. Not all stations offer PDC, in which case the player will start at the time you enter and not the actual start time of the programme.

If you wish to start recording at a specific time without it being adjusted by the PDC system in the event of a delay, switch PDC off otherwise the player will not record.

•If you don’t have the VideoPlus numbers see next page for the normal timer.

•If you have made a mistake, move back to the relevant position with the [<] button and change the setting.

•If there is no programme location displayed under “PR” in the change menu, the player doesn’t yet know the location number for the programme you want. Type it in and this will be stored for last recordings.

•If you wish to record from a satellite receiver, select under “PR” the satellite programme location or AV (1/2) (depending on the connection with the antenna cable or the SCART- cable). Leave the satellite tuner switched on and to the programme you want.

•Should programming overlap, you get a warning.

•To cancel the recording press the button (stop) more than 5 seconds.

•VideoPlus is a trademark applied for by Gemstar Development Corp.. The VideoPlus system is manufactured under license from Gemstar Development Corporation.

36