Energy-Saving Tips
Your Room Air Conditioner is designed to be highly efficient in energy savings.
Follow these recommendations for greater efficiency.
1.Select thermostat setting that suits your comfort needs and leave thermostat at that chosen setting.
2.The filter is very efficient in removing airborne particles. Keep air filter clean. Normally, filter should be cleaned every 2 weeks. More frequent cleaning may be necessary depending on indoor air quality.
3.Use drapes, curtains, or shades to keep
direct sunlight from heating room, but DO NOT obstruct the air conditioner. Allow air to circulate around the unit without obstruction.
4.Start your air conditioner before outdoor air becomes hot and uncomfortable. This avoids an initial period of discomfort while unit is cooling off the room.
5.When outdoor temperatures are cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting.
Installation Notes
Electric Shock Hazard
To avoid the possibility of personal injury, disconnect power to the unit before installing or servicing.
Tools Needed for Installation
Screw Drivers: Both Phillips and flat head
Power Drill: 1/8 inch (3.2 mm) diameter drill bit
Pencil
Measuring Tape
Scissors
Carpenters Level
CAUTION
To avoid installation/operation difficulties,
read these instructions thoroughly.
Your Room Air Conditioner is designed for easy installation in a single or
NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Remove from carton, the plastic bag containing the installation hardware kit necessary for the installation of your air conditioner. Please check the contents of hardware kit against the corresponding model check list, prior to installation of the unit. See Fig. 1
Installation Hardware | ||
3/4" (19.1 mm) | Safety Lock (1) | |
Screws (9) |
| |
*3/8" (9.5 mm) Screws | *“L” Shaped | |
mounting bracket | ||
(4) | ||
(1) | ||
*Factory installed on | ||
some models. | *Factory installed | |
| ||
| on some models. | |
| Sash bracket (2) | |
Adhesive |
| |
Foam Seal (1) |
| |
Side Curtain RH (1) | ||
Side Curtain LH (1) |
| |
Fig. 1 |
| |
4
