Danby DCD5505W-1 manuel dutilisation Drying stage indicator, Start button, After drying

OPERATING INSTRUCTIONS

The drying temperature is selected automatically by the selection of the drying program, and it is lower for delicate laundry than for the resistant one. During the drying program with preset time the temperature is the same for both the delicate and resistant laundry.

Drying stage indicator

Damp for machine ironing

Damp for ironing

Mildly damp

Dry for storage

Very dry

Anti crease

End

The drying stage indicator displays the actual drying stage at any given moment. This is signaled by the indicator light, illuminated adjacent to a particular drying stage symbol. The end of drying is signaled by the indicator light END or ANTI-CREASE.

START button

This button starts the operation of the appliance. In case of program interruption (open door, voltage failure, condensation receptacle full), it serves to continue the actual program, after the cause for interruption had been removed.

Drying

laundry and the extent of moisture present in the laundry (after the final spin stage of the wash program).

Actual stage of moisture during the program is indicated by the moisture stage display, so you may remove particular pieces of clothing you wish to remain damp at any time during the program. When you open the door (add or remove pieces of laundry) the drying program stops automatically and the drum interior is illuminated. When you close the door the light goes off and the program continues by pressing the START button.

In case of a power failure during a selected program, the drying operation stops. When the power is reinstated, you must to press the START button to continue the program.

Each program concludes with a 10 minute cooling down period, to prevent extracting hot laundry from the appliance and to improve the anti-crease function.

Drying programs are complete when the signal beep sounds and the indicator light “END” and “ANTI-CREASE” illuminate at the end of the program. This indicates that the laundry is dried to the point of the preset moisture stage, or the preset drying time has expired. The drum stops and laundry may be removed from the machine.

NOTE: If the laundry is not removed immediately after the drying cycle is completed, (and the machine is not switched off) the dryer will automatically start a special anti crease program. ANTI-CREASE PROGRAM: Consist of:

•5 minute “OFF” (dormant) cycle

•5 second “ON” tumbling cycle (ho heat)

This program helps to prevent laundry from sitting idle in the same position and helps to reduce creasing/wrinkling. The “anti-crease” program stops automatically after one hour of operation, but may be interrupted at any time by opening the door or turning the appliance off.

After drying

•Open the dryer door. Remove and clean the lint filter. If the filter is not cleaned regularly, the air circulation is obstructed. This obstruction will increase the drying time and may cause the unit to overheat and fail.

•Reinsert the filter.

•Remove laundry from the drum.

•Close the door and disconnect the power supply.

Drying time depends upon the selected program and the quantity of laundry. If you selected time defined drying the machine stops upon the expiry of set time. If you selected any of the programs for automatic determination of moisture, drying time will largely depend upon the quantity of

Instructions for Use 11