Danby DPAC 9009 OPERATING INSTRUCTIONS cont’d, Control Buttons, Batteries should be replaced when

OPERATING INSTRUCTIONS (cont’d)

AUTO-TIMER	The AUTO-TIMER feature offers a unique selection of multiple
	choice, fully automatic on and/or off (start/stop) programs between
	1-24 hours under any one mode of your Home Comfort unit.

The programs are as follows:

a)Auto-Off: Pre-select a time that will turn off the unit automatically (between 1-12hrs).

b)Auto-On: Pre-select a time that will turn on the unit automatically (between 1-12hrs).

c)Auto-On & Auto Off: Pre-select a time that will turn the unit ON / OFF automatically at specified times (between 1-12hrs).

Note: These functions must be performed daily, as the program is automatically canceled/erased after the program has ended.

REMOTE CONTROL

FEATURES

Control Buttons:

1)Power Switch

2)Mode

3)Fan Speed

4)On / Off Timer

5)Time / Temperature Set

•Used for adjusting the timer and temperature.

•The default display on control panel is room temperature.

•When key is pressed in cool mode, the set temperature is displayed and may be adjusted. After 10 seconds the display will revert back to room temperature.

•Timer setting is available from 1-24 hours by pressing the key

To operate the hand held remote control you will require two “AAA” Alkaline batteries (included).

Batteries should be replaced when:

a)No signal (beep) is heard when attempting to program the main unit.

b)The main unit does not respond to a command issued by the remote control.

Battery replacement:

1) Slide the rear cover on the remote in the direction of the arrow. Continue pulling (gently) until the cover separates completely from the unit.

2) Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery chamber (+ / -).

3) Re-install rear cover.

4) If the remote control will not be used for extended periods of time (vacations, etc.), batteries should be removed.

The remote operates within a range of 8 meters (26 ft.) from the receiver located inside the main unit. Any obstruction between the receiver and remote may cause signal interference, limiting the ability to program the unit.

Notes:

1)Do not drop the remote control.

2)Do not place the remote control in a location exposed to direct sunlight.

3)The remote control should be placed about 1 meter or more away from TV, or any electrical appliances.

This Class B digital apparatus complies with canadian ICES-003.

9