Changing Passwords | Dane-Elec Memory MD-H101T1E23S

my-DittoUser Manual

6.Remove my-Ditto key.

7.Plug my-Ditto key into your PC.

8.Launch my-Ditto application.

9.Enter username and password.

7.2.2 Start using a New Mobile Phone

First you should verify your email addresses and install the software (refer to section 4‎ .4.2 Access from a Mobile Device, on page 15).

1.Make sure my-Ditto is turned ON.

2.Plug in my-Ditto key to the USB1 port located on the front panel.

3.Wait until the USB1 LED is illuminated.

4.Press the COPY button for 4 sec. or until a beep is heard.

5.Wait a few seconds until you hear two short beeps; the USB1 LED will turn off (the USB1 LED will flash briefly before it turns off).

6.Remove my-Ditto key, and your previous password has been cleared.

7.When launching the application, you will be asked to type in a new password and confirm it.