DAVIS 6322C installation manual Preparing the ISS for Installation, Hardware, Tools for Setup

Preparing the ISS for Installation

Note:	If the ISS is a Plus model and contains UV and solar sensors, do not touch the small white diffusers
	on top of the sensors. Oil from skin reduces their sensitivity. If you are concerned that you have
	touched the diffusers at any time during the installation, clean the UV diffuser using ethyl alcohol
	with a soft cloth. When cleaning the UV diffuser, DO NOT use rubbing or denatured alcohols
	because they can affect accuracy of the sensor readings. Ethyl alcohol can be procured through an
	industrial or laboratory supply store. Clean the solar diffuser with a soft damp cloth.

Hardware

The following hardware is included with the ISS and weather station assembly. Some of the hardware is optional based on how the ISS is assembled and installed. (See “Installing the ISS” on page 19 for more information.)

U-Bolts

1/4" Flat Washers

1/4" Lock Washers

1/4" Hex Nuts

Backing Plate	.05" Allen
	Wrench
8" Cable Tie

1/4" x 3" Lag Screws

#4 x 1-1/8"

Machine Screw

#4 Tooth

Lock Washer

#4-40 Hex Nut

3-Volt Lithium Battery (wireless models

only)

Note:	If any of the hardware components are missing or not included, contact Customer Service toll free
	at 1-800-678-3669 about receiving replacement hardware or other components.

Tools for Setup

The following are additional tools required to set up and install the ISS:

•Small Phillips head screwdriver

•Scissors or wire-cutters

•Adjustable wrench or 7/16" wrench

•Compass or local area map

•Ballpoint pen or paper clip (or other small pointed object)

•Drill and 3/16" (5 mm) drill bit (if mounting on a vertical surface)

Preparing the ISS for Installation

Please follow the steps in the order they are presented. Each step builds on tasks completed in previous steps.

Note: Using a well-lit work table or work area to prepare the ISS for installation is recommended.

2