DAVIS 6322C installation manual Assemble the Anemometer

Preparing the ISS for Installation

The steps to prepare the ISS for installation are:

•Assemble the anemometer.

•Check the factory-installed sensor cable connections to the SIM.

•Connect the anemometer sensor cable to the SIM.

•Apply power to the ISS and test communication with the console.

•Change the Transmitter ID for wireless communication, if necessary.

Assemble the Anemometer

The anemometer measures wind direction and speed. The anemometer arm comes partially assembled with the wind vane attached. The anemometer arm requires assembly before it can be assembled with the rest of the ISS.

Please locate the following parts to prepare the anemometer:

•Anemometer arm (wind vane and cable already attached)

•Anemometer base

•Wind cups

•Allen wrench (0.05")

•#4 machine screw, #4 tooth-lock washer, #4 hex nut

Attaching Anemometer Arm to Base

1.Insert the anemometer arm into the base, sliding the cable through the notch in the base as shown in illustration.

2.Be sure to line up the small hole in the arm with the holes in the base.

3.Insert the machine screw through the holes in the base and arm.

Insert anemomter arm into base

#4 Tooth

Lock Washer

Hex Nut

Slide cable

through notch

#4 x 1-1/8"

Machine

Screw

Important: Press cable firmly

into channel

3