Check SIM Sensor Connections
Connect the Anemometer Cable to the SIM
1. Unwind the coil of cable enough to work with the anemometer.
Note: | Do not unwind the entire coil of anemometer cable at this time. |
2.Pull the foam insert out of cable access port in between the cables and set the foam insert aside.
3.Insert the anemometer cable end into the cable access port from beneath the SIM box.
Slide the cable through the cable access port with the connector lever down.
4.Firmly insert the end of the anemometer cable into the connector labeled WIND.
The lever clicks into place.
5.Make sure that the cables lie flat on the bottom the cable access port.
Foam Insert
6. Firmly insert the foam in between the cables and at the top of the cable access port, taking care to ensure that the foam seals the
access port entirely, leaving no holes or gaps large enough for weather or insects.
Note: | If you are assembling a cabled station, wait to reinsert the foam until cable assembly is com- |
| plete. See “Cabled ISS Assembly” on page 7. |
Once the sensor connections have been checked and the anemometer cable has been inserted, a connection between the ISS and the Vantage Pro2 console must be made.
7.Read the following instructions that best apply to your ISS and Vantage Pro2 assem- bly:
•See “Cabled ISS Assembly” on page 7 for assembling Vantage Pro2 weather sta- tions that contain a cabled connection between the ISS and the console.
•See “Wireless ISS Assembly” on page 9 for assembling Vantage Pro2 weather sta- tions that use a wireless connection to transmit and receive data.
6
