Cisco Systems Cisco 815 10

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

The user prompt appears:

Router>

To verify that the new interfaces are operating correctly, enter the following commands:

•show interfaces—Verifies that the interfaces are operating correctly and that the interfaces and line protocol are in the

correct state—up or down.

•show ip interface brief—Displays a summary status of the interfaces configured for IP.

•show configuration—Verifies that you configured the correct hostname and password.

After you complete and verify the initial configuration, your Cisco 815 integrated services router is ready to be configured for

specific functions. See the “Where to Go Next” section on page 22 for information about locating documentation for advanced

configuration procedures.

10 Where to Go Next

For additional configuration procedures, see the appropriate Cisco 815 integrated services router documentation or Cisco IOS

software documentation, available online on Cisco.com.

Tip See the “Obtaining Additional Publications and Information” section on page 26 for help in locating these documents.

For Cisco 815 integrated services router platform documentation, begin at Cisco.com at http://www.cisco.com, and choose

Technical Support & Documentation> Documentation > Routers > Cisco 800 Series Routers > Cisco 815 Integrated Services

Router document type > Document.

For Cisco IOS software documentation, begin at Cisco.com at http://www.cisco.com, and choose Products & Solutions > Cisco

IOS Software > Latest Releases > Your Cisco IOS software release.

For updated information about platform support for features, access Feature Navigator II at http://www.cisco.com/go/fn. (This

requires a registered account on Cisco.com.)

For Cisco 815 integrated services router platform documentation, begin at Cisco.com at http://www.cisco.com, and click the

Technical Support and Documentation link. Click the Former Technical Documentation site link, and navigate to Modular

Access Routers and to the documentation for your router.

For Cisco IOS software documentation, begin at Cisco.com at http://www.cisco.com, and click the Technical Support and

Documentation link. Click the Former Technical Documentation site link and navigate to the Cisco IOS software documentation

for the Cisco IOS software release that is installed on your router.