Dayton 3VH37 Safety Signs and Labels, Back Panel, Bottom Panel, Dayton High Intensity Heaters

	3E132 thru 3E134, 3E460 thru 3E462,
Dayton Installation, Operation, Maintenance and Parts Manual	5VD57 thru 5VD66, 3VH34 thru 3VH37

Dayton® High Intensity Heaters

Safety Signs and Labels

It is important to provide warnings to alert individuals to potential hazards and safety actions. ANSI Z83.19a and the National Fuel Gas Code require you to post a sign “specifying the maximum permissible stacking height to maintain the

Erequired clearances from the heater to the combustibles”

Nnear the heaters thermostat or in absence of such

Gthermostats in a conspicuous location. Signs should state the

Lhazards for the particular application and be legible to the

Ibuilding occupants. Consult the factory or a factory

Srepresentative for additional information on signage H compliance.

Back Panel

Safety warning labels must be maintained on the infra-red heater. Illustrations of the safety labels, and their locations, are pictured below.

DAYTON INFRA-RED RADIANT HEATER

FOR INDOOR INSTALLATION ONLY

MODEL NO.

INPUT BTU/H

FOR USE WITH

3E133E

60,000

NAT GAS

DESIGN COMPLIES WITH:

Manifold Pressure

6.0in.

W.C.P.

ANS Z83.19-2001-GAS FIRED HIGH INTENSITY INFRA-RED HTR.

ax. Inlet Pressure

14.0in.

W.C.P.

VOLTS AC

60Hz

120V

in. Inlet Pressure for

7.0in.

W.C.P.

Purpose of Input Adjustment

AMPS - Starting

0.1

Min. Mounting Angle

20 DEGREES

AMPS - Running

0.1

Max. Mounting Angle

35 DEGREES

Heater Type:

C1

MANUFACTURED FOR:

Serial No. 0603DETR 21400 0001

DAYTON ELECTRIC MFG. CO.

NILES, IL 60714

U.S.A.

Bottom Panel

Rating Plate

F/N: LLDR002

! WARNING

AVOID SERIOUS INJURY, DEATH OR PROPERTY DAMAGE.

Maintain Clearances to Combustibles to Prevent the Risk of Fire.

Clearances to combustibles must be maintained in order to prevent the ignition of combustible materials. In locations used for the storage of combustible materials, signs must be posted to specify the maximum permissible stacking height to maintain the required clearances from the heater to the combustibles. Signs must either be posted adjacent to the heater thermostats or in the absence of such thermostats in a conspicuous location. Clearances are provided on the heater’s safety labels and in the heater’s Installation & Operation Manual. Refer to applicable ANSI orNFPA-54 Standards or local codes for further information. Post this tag adjacent to the heater’s thermostat or controls before operating the heater.

INSTALLER. READ AND POST THIS NOTICE.

F/N: LL01 - Clearance Safety Tag (Affix adjacent to heater’s thermostat)

F/N: LLDCL002

8