Dayton Operating Instructions and Parts Manual | 2E510F, 2E511F, 3E218F, and 3E219F |
Dayton® Portable
Maintenance
Never service heater while it is
plugged in, operating, or hot. Severe burns and electrical shock can occur.
UPPER SHELL REMOVAL
1.Remove screws along each side of heater using 5/16"
2.Lift upper shell off.
3.Remove fan guard.
FAN
IMPORTANT: Remove fan from motor shaft before removing motor from heater. The weight of the motor resting on the fan could damage the fan pitch.
1.Remove upper shell (see Figures 7 and 8).
2.Use 1/8" Allen wrench to loosen setscrew which holds fan to motor shaft.
3.Slip fan off motor shaft.
4.Clean fan using a soft cloth moist- ened with Kerosene or solvent.
AIR OUTPUT, AIR INTAKE, AND LINT FILTERS
1.Remove upper shell (See Figures 7 and 8).
2.Remove filter end cover screws using 5/16"
3.Remove filter end cover.
4.Replace air output and lint filters.
5.Wash and dry with soap and water or replace air intake filter.
6.Replace filter end cover.
7.Replace fan guard and upper shell.
Upper Shell
Fan Guard
Figure 7 - Upper Shell Removal, Models 2E510F and 2E511F
5. Dry fan thoroughly. | IMPORTANT: Do not oil filters. | |
| ||
6. Replace fan on motor shaft. Place | Air Intake Filter | |
Filter End Cover | ||
fan hub flush with end of motor | ||
Fan Guard | ||
shaft (See Figure 9). | ||
|
7.Place setscrew on flat of shaft. Tighten setscrew firmly
8.Replace fan guard and upper shell.
Fan | Lint Filter |
|
Motor
Air Output Filter
Setscrew
Figure 10 - Air Output, Air Intake, and
Lint Filters, Models 2E510F and 2E511F
Upper Shell
Flush
Motor
Shaft
Air Intake Filter
Filter End Cover
Fan
Guard
Figure 8 - Upper Shell Removal, Models 3E218F and 3E219F
Lint
Filter
Figure 9 - Fan Cross Section | Air Output | |
Filter | ||
|
Fan Guard
Figure 11 - Air Output, Air Intake, and
Lint Filters, Models 3E218F and 3E219F
6
