dCS Verona User Manual

Manual for Software Issue 1.0x

dCS Ltd

September 2004

 

 

Bright x - Display Brightness

This adjusts the brightness of the main display, with settings between 7 (brightest) and 0 (off, unless something is touched).

do this: Open the Menu and step through until the display shows Bright x, where x is a number between 7 and 0.

do this: Press the Select button repeatedly and the display cycles through Bright 7, Bright 6, ......., Bright 1, Bright 0 and back to Bright 7.

After time-out, a setting of Bright 0 blanks the display unless the unit is not locked. Operating any control or locking to a source while in this mode turns the display back on momentarily.

TimeOut – Menu Time Out Setting

If you find the 5 second time out period for the menu is too short, use this option to change the time out period.

do this: Open the Menu and step through until the display shows Timeout.

do this: Press the Select button repeatedly and the display will cycle through the options: None, 5 secs, 15 secs, 30 secs, 1 min, 3 mins.

When set to None, the menu does not close automatically. Close it manually by stepping through to the End page and pressing Select.

do this: Choose the setting you want and press the Select button again.

Test - Display Test

This runs a test routine to ensure the display is working correctly.

do this: Open the Menu and step through until the display shows Test.

do this: Press the Select button once to start the test.

The main display lights up then fades from bottom to top.

The indicator LEDs light up briefly in sequence.

All indicators light up, along with small squares on the main display. This flashes off and on once.

The display shows Done.

Issue – Software Issue State

This displays the issue number of the software fitted to your unit. You will need to check this if you are considering a software upgrade or if your unit malfunctions.

do this: Open the Menu and step through until the display shows Issue.

do this: Press the Select button once to display the software issue.

do this: For units fitted with a 1394 interface, press the Select button again to display the 1394 interface software issue.

Temp – Unit Internal Temperature

This displays the temperature inside the unit, close to the crystal oscillators.

do this: Open the Menu and page through until the display shows Temp.

do this: Press the Select button once to display the temperature in degrees Fahrenheit. Press Select again to change to degrees Celsius.

Manual filename: Verona Manual v1.0x.doc

Page 16

email: more@dcsltd.co.uk

English version

 

web-site: www.dcsltd.co.uk