dCS Verona User Manual | Manual for Software Issue 1.0x |
dCS Ltd | September 2004 |
|
|
The 1394 interface in not fitted in this release. It is intended for future enhancements.
Power LinkThis can be linked to similar connectors on other dCS units using a link cable. All units linked in this way may be turned on or off or set to standby by pressing a single Power button or sending one Remote Control command. Link cables are available from dCS.
SUC
The Software Upgrade Connector is intended to be used by dCS service agents to load new software into Verona.
IMPORTANT! Do not connect any other equipment to the SUC connector as this may damage both Verona and the equipment so connected. Do not operate Verona with a PC connected. Failure to observe this warning will void the unit’s warranty, and may cause unpleasant effects in your system.
Power switch
The Power switch completely isolates the unit from the power supply. In normal use, set it to the On position (I). Set it to Off (0) during electrical storms, or while you are away for a long period.
IEC Power InletUse with a 3 - pin IEC type power cable.
Mains FuseReplace only with a 20 x 5mm 500mA T HRC fuse. Please see page 32 for replacement details.
Additional InformationThe rear panel displays the following information about the unit:
•The manufacturer’s name and address.
•Supply voltage setting, frequency range and rated power.
•Model: dCS Verona•The short form of the unit serial number.
We will need the serial number (preferably the full serial number from the menu) to give you support over the phone, or to ship you software updates.
Manual filename: Verona Manual v1.0x.doc | Page 23 | email: more@dcsltd.co.uk |
English version |
|