dCS Verona User Manual | Manual for Software Issue 1.0x |
dCS Ltd | September 2004 |
|
|
TROUBLESHOOTING
Fault Indication
Verona detects the following fault conditions:
Power interruption
If the AC supply is momentarily interrupted or is more than 20% below it’s rated voltage, the unit displays PowerDn and mutes the audio outputs to protect your loudspeakers from damage. This may be caused by loose AC power wiring, local
Power up test errors
If Verona detects a fault during its power up test routine, it will remain muted and display one of these messages:
•DSPs Not Loaded (#01)
•FPGAs Not loaded (#02)
•Bad Checksum. Press any key to attempt recovery (#03)
•DSP-Err1 (#04)
This can be caused by power line transients occurring configuration. For Bad Checksum, press any button to try to Otherwise, try switching off, waiting 20 seconds, then switching fault persists, please consult your dealer.
during system clear the fault. on again. If the
Manual filename: Verona Manual v1.0x.doc | Page 36 | email: more@dcsltd.co.uk |
English version |
|