dCS Verona User Manual | Manual for Software Issue 1.0x |
dCS Ltd | September 2004 |
|
|
STEP-BY-STEP GUIDE
This section guides you through setting up the unit for basic operation. You may find this useful if you have not used the Verona for a while.
Preliminaries
The Control Summary sheet details the menu structure and outlines the use of the front panel controls. For more information, see the Menu section on page 14.
For digital interfaces, use with cables designed for digital audio:
• for Word Clock interfaces, use 75Ω coax cables fitted with BNC plugs.
•for SPDIF RCA interfaces, use 75Ω coax cables fitted with RCA Phono plugs.
do this: Connect the power cable supplied to the Power inlet on the Verona rear panel, plug the other end into a convenient power outlet. Set the power switch beside the power inlet to the on position (I).
IMPORTANT! Please do not use an excessively thick power cable as this may damage the power inlet connector. Such damage is not covered by the warranty.
do this: Press the Power button and wait about 5 seconds while Verona configures itself.
The display will show in sequence: Verona, Testing and either 44.1kHz or
48kHz.
If the unit is likely to be set in an unfamiliar state, you can reset it as follows:
do this: Press the Menu button once, then press the Step Back button so the display shows Factory. Press the Select button and wait a second.
The unit will display Defaults. The PWR indicator and perhaps the OK indicator will be lit, the others should be off.
Manual filename: Verona Manual v1.0x.doc | Page 8 | email: more@dcsltd.co.uk |
English version |
|