Defy Appliances 5718140000/AA instruction manual Separate the union from the tap adaptor. Figure A

Connection of the Water Pipe to the Cold Water Mains Line (in some models)

If you want to use your refrigerator by connecting it to the cold water mains line, you will have to connect a standard 1/2” valve connection fitting to the cold water supply in your house. (In case this valve is not present or if you are unsure, please consult a qualified plumber).

1.Separate the union from the tap adaptor. (Figure A).

2.Install the tap adaptor to a 1/2” valve fitting as shown in the figure. (Figure B).

3.After inserting the water pipe to the union, install it to the tap adaptor and insert to the tap as shown in the figure. (Figure C).

4.Tighten the union manually. In case of a leak use a correctly sized spanner to tighten the union.

Warning:

Secure the water pipe to suitable points by means of the pipe clips supplied to avoid any damage or displacement or accidental disconnection.

Warning:

After turning on the water valve, make sure that there is no leakage at both connection points of the water pipe. In case of a leak, turn off the valve immediately and tighten all joints again using a correctly sized spanner.

Warning:

Make sure that standard 1/2" valve fitting fed by the cold mains water supply is available and is turned off fully.

Note -1:

There is no need to use a water filter in case a jug is used.

Note -2:

A pump must be used when using the jug.

PAGE 16