8Maintenance and Cleaning
•Always disconnect the plug from the mains socket before cleaning.
•Note that turning the thermostat to ‘0’ does not switch the power off to the refrigerator.
•Clean the inside of the refrigerator when necessary by using a solution of one table spoon of Bicarbonate of Soda to two litres of warm water.
•Dry with a soft cloth.
•Do not use pot scorers or abrasive powders to clean the refrigerator.
•Spillages, especially citric and acidic juices, must be wiped up immediately as they could stain the interior of the refrigerator.
•Shelves and freezer baskets, where fitted, may be removed for cleaning purposes.
•The back of the refrigerator may be vacuumed or dusted using a soft bristle brush.
•A mild furniture polish may be used on the exterior cabinet to add lustre and protect against finger marks.
•Make sure that no water enters the lamp housing and other electrical items.
•If your refrigerator is not going to be used for a long period of time, unplug the power cable, remove all food, clean it and leave the door ajar.
•Check door seals regularly to ensure they are clean and free from food particles.
•To remove door racks, remove all the contents and then simply push the door rack upwards from the base.
Owner’s responsibility
•Do not damage the refrigerant circuit.
•Do not use electrical appliances inside the food storage compartments of the appliance, unless they have been recommended by the manufacturer.
Since the following are not factory faults they are the owners responsibility:
•Damage to the exterior finish.
•Breakage of glass and other components.
•Replacement of light bulbs.
•Damage caused through improper use of the appliance.
•Damage caused by moving the appliance.
Protection of plastic surfaces
Do not place liquid oils or oilcooked meals in your refrigerator in unsealed containers as they may damage the plastic surfaces of your refrigerator.
In case of spilling or smearing oil on the plastic surfaces, clean and rinse the relevant part of the surface at once with warm water.
Replacing the Interior Light Bulb
(See diagrams on following page)
Should the light fail to work, proceed as follows:
1.Switch off at the socket outlet and pull out the mains plug.
Remove all shelves and drawers for easy access.
2.Illumination covers in freezer and fridge sections are opened by pressing by hand; first release one side and then the other by pressing on the sides as shown in the figures on the following page.
3.First check that the bulb has not worked loose by ensuring that it is screwed securely into the holder. Reinsert the plug and switch on. If the bulb works, reinstall the light cover by inserting the rear lug and pushing up to locate the front two lugs.
4.If the light still fails to work, switch off at the socket outlet and pull out the mains plug. Replace the bulb with a new 15 watt (max) screw cap E14 (SES) bulb.
5.Carefully dispose of the burntout light bulb immediately.
Replacement light bulbs can easily be obtained from a good local electrical or DIY store.
PAGE 27
