Before first use of Ice/Water Dispenser
Water mains pressure must not be below 1 bar.
Water mains pressure must not be over 8 bars.
Pumps must be used in case the supply water pressure drops below 1 bar or if a jug is going to be used.
The water system of the refrigerator must be connected to the cold water line. It must not be connected to the hot water line.
No water may be obtained in the initial start up of the refrigerator. This is caused by the air in the system. To discharge air from the system, press the Dispenser latch for 1 minute periods until water flows from the Dispenser. Water flow may be irregular in the beginning. Irregular water flow will be normalized after the air in the system is discharged.
After the initial startup of the refrigerator approximately 12 hours must pass before cold water can be obtained.
Water mains pressure must be between 18 bars for the operation of Ice/Water Dispenser smoothly. For this, check that 1 glass of water (100 cc) can be filled in 10 seconds.
The first 10 glasses of water should not be consumed.
Please note, ice cubes will not be ready for the first 12 hours after switching on the refrigerator.
If there is not enough ice in the ice dispenser, ice may not be obtained from ice dispenser.
The first 30 cubes of ice to be obtained from the Ice Dispenser must not be used.
Always use the water filter when a jug is not being used.
Open door warning
An audio warning will be given when the fridge or freezer compartment door of your refrigerator is left open for a certain period of time. This audio warning signal will mute when any button on the indicator is pressed or when the door is closed.
PAGE 17
