SEMI-AUTOKEYSTONE—Press the button on the control panel or the Menu button on the remote control to activate the Semi-Auto Keystone correction for image distortion.
ASPECT RATIO—Select an aspect ratio to adjust how the image appears.
•1:1 — The input source displays without scaling.
Use 1:1 aspect ratio if you are using one of the following:
–VGA cable and the computer has a resolution less than XGA (1024 x 768)
–Component cable (576p/480i/480p)
–S-Video cable
–Composite cable
•16:9 — The input source scales to fit the width of the screen.
•4:3 — The input source scales to fit the screen. Use 16:9 or 4:3 if you are using one of the following:
–Computer resolution greater than XGA
–Component cable (1080i or 720p)
VIDEO MODE—Select a mode to optimize the display image based on how the projector is being used: Movie, PC, sRGB (provides more accurate color representation), and User (set your preferred settings). If you adjust the settings for White Intensity or Degamma, the projector automatically switches to User.
WHITE INTENSITY—Select 0 to maximize the color reproduction and 10 to maximize the brightness.
DEGAMMA—Adjust between 1 and 6 to change the color performance of the display. The default setting is 0.
Computer Image Menu
NOTE: This menu is only available when a computer is connected.
FREQUENCY—Change the display data clock frequency to match the frequency of your computer graphics card. If you see a vertical flickering bar, use Frequency control to minimize the bars. This is a coarse adjustment.
TRACKING—Synchronize the phase of the display signal with the graphics card. If you experience an unstable or flickering image, use Tracking to correct it. This is a fine adjustment.
NOTE: Adjust Frequency first and then Tracking.