Marking the Rack
CAUTION: If you are installing more than one system, install the first system in the lowest available position in the rack.
1.Determine where you want to place the bottom of the system.
2.Place the
3.Align the bottom of the template with the desired bottom position of the system chassis.
4.Mark the upper and lower mounting positions on the vertical rails as shown by the
Each
1.75 inches (1 U)
0.5inch
0.625 inch
0.625 inch
0.5 inch
Figure 1-2. Two-Post Open-Frame Relay Rack 1-U Hole Spacing
support.dell.com | Rack Installation Guide |