Dell 1500 manual Replacing the Rack Doors on a 42-U Rack, Replacing the Rack Doors on a 24-U Rack

7.Slide the system in and out of the rack to verify that the cables are routed correctly and do not bind, stretch, or pinch with the movement of the cable- management arm.

NOTE: As you pull the system out to its furthest extension, the slide assemblies will lock in the extended position. To push the system back into the rack, press the locking latch on the side of the slide assembly to release the locks, and then slide the system completely into the rack.

Replacing the Rack Doors on a 42-U Rack

CAUTION: To prevent personal injury due to the size and weight of the doors, never attempt to remove or replace the doors by yourself.

1.Lift the front door into position and align the hinges with the holes in the rack as shown in Figure 1-9.

2.Slide the hinges into the holes in the rack until the hinge release levers lock the hinges into position.

3.Close the door latch by rotating the handle counterclockwise until it stops, push the handle in until it locks in position, and then slide the button cover down over the push button (see Figure 1-8).

4.Repeat steps 1 through 3 to install the back door.

Replacing the Rack Doors on a 24-U Rack

CAUTION: To prevent personal injury due to the size and weight of the doors, never attempt to remove or replace the doors by yourself.

1.Lift the front door into position and align the hinges with the holes in the rack (see Figure 1-11).

2.Line up the door hinges and then press down on the hinge pins.

3.Close the door latch by rotating the handle counterclockwise until it stops, and then push the handle in until it locks in position (see Figure 1-10).

4.Repeat steps 1 through 3 to install the back door.

5.Attach the front bezel to the system, if it is not already attached (see the Installa- tion and Troubleshooting Guide for instructions).

This completes the four-post rack kit installation.

1-26 Rack Installation Guide