Attaching the Brackets
1.Measure the rack to determine if the two-post relay rack is 3 inches wide or
6 inches wide. The rearmost bracket on each side can be positioned for either 3- or 6-inch wide racks.
2.Align a bracket on the right side of the chassis, oriented so that the flange that fastens to the two-post rack is facing backward. The two top mounting holes must be aligned with the fourth and fifth holes on the side of the system chassis (see Figure 1-3).
3.Secure the front bracket to the system chassis using two 10-32 x 0.25-inch screws (see Figure 1-3).
Repeat this step to install the remaining front bracket to the other side of the system chassis.
holes for 3-inch wide rack
fifth hole from front
12-24 x 0.5-inch pan-head Phillips screws (2 per bracket)
hole for 6-inch wide rack (only front hole is used)
10-32 x 0.25-inch pan-head Phillips screws (For 3-inch wide rack: 2 per bracket. For 6-inch wide rack: 2 per front bracket, 1 per back bracket)
Figure 1-3. Securing the System in the Rack
1-4 Rack Installation Guide