Back to Contents Page
Display
Dell Studio™ 1555 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Hinges
Display Assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the computer.
Removing the Display Assembly
1.Follow the instructions in Before You Begin.
2.Remove the base cover (see Removing the Base Cover).
3.Disconnect the antenna cables from the
4.Lift the antenna cables from the securing tabs and release them from the routing channel.
1 | securing tabs | 2 | antenna cables |
|
|
|
|
5. Remove the two screws securing the display assembly from the bottom of the computer.
6. Remove the center control cover (see Removing the Center Control Cover).
