![](/images/new-backgrounds/1120040/120040191x1.webp)
(gold finger and square pad)
Figure 7-10. Pin-1 Identification
Pin 1 is located in the lower right corner of the socket as you face the “Socket 8” label (Figure
8.Install the microprocessor chip in the socket (Fig- ure 7-11).
CAUTION: Positioning the microprocessor chip incorrectly in the socket can perma- nently damage the chip and the computer when you turn on the system.
If the release lever on the microprocessor socket is not all the way up, move it to that position now.
With the
CAUTION: When placing the micro- processor chip in the socket, be sure that all of the pins go into the corresponding holes on all sides of the socket. Be careful not to bend the pins.
When the chip is fully seated in the socket, rotate the socket release lever back down until it snaps into place, securing the chip.
Figure 7-11. Installing the Microprocessor Chip
9.Place the new heat sink (with its bonded thermal interface pad) on top of the microprocessor chip (see Figure