6-76 Dell PowerEdge 2100/180 and 2100/200 Systems User’s Guide
System Orientation
All directions presented in the procedures in this chapter
are as viewed from a position facing the front of the
computer.
Removing the Computer Cover
Use the following procedure to remove the computer
cover:
1. Observe the Warning for Your Personal Safety and
Protection of Your Equipment in the previous sec-
tion. Also observe the safety instructions at the
front of this guide.
2. Remove the four cover-mounting screws that
secure the cover to the chassis (Figure 6-1).
Use the key provided with the system to remove the
special keylock screw if it is installed in one of the
cover-mounting screw locations. See Figure 1-2 for
an illustration of the keylock screw and key.
3. Slide the cover backward about one inch. Then
grasp the front of the cover and the handle at the
back of the cover, and lift it straight up off the
chassis (Figure 6-1).
Figure 6-1. Removing the Computer Cover
Replacing the Computer Cover
Use the following procedure to replace the computer
cover:
1. Check all cable connections, especially those that
might have come loose during your work. Fold
cables out of the way so that they do not catch on
the computer cover.
CAUTION: Make sure that there are no cables
or cable connectors lying on the diskette drive.
Foreign objects on top of the drive can inter-
fere with drive operation and permanently
damage the drive.
cover-mounting screws (4)
handle