Back to Contents Page

Setting Up the Monitor

Dell™ P1911 Flat Panel Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing Your Cables

Attaching the Soundbar (optional)

Removing the Stand

Wall Mounting (Optional)

Attaching the Stand

NOTE: The stand is detached when the monitor is shipped from the factory.

NOTE: This is applicable for a monitor with a stand. When the OptiPlex™ USFF 780/ OptiPlex™ SFF 980 AIO stand is bought, please refer to the respective guide for set up instructions.

To attach the monitor stand:

1.Place the stand on a flat surface

2.Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.

3.Lower the monitor so that the monitor mounting area snaps ontoorlocks on to the stand.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.

To connect your monitor to the computer:

1.Turn off your computer and disconnect the power cable.

2.Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.

Connecting the white DVI cable

Page 31
Image 31
Dell P1911, 469-0052 Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor, Connecting the white DVI cable