Dell 6x00, 4x00 manual LJXUH,QVWDOOLQJWKH6OLGH$VVHPEOLHV

5.Using a Phillips screwdriver, slightly loosen the slide alignment screws that hold the front slide-assembly mounting bracket to the exterior slide (see Figure 7).

NOTE: Do not adjust the back slide-assembly mounting brackets. Doing so will prevent the computer from aligning properly with the rack. Make adjustments only to the front slide-assembly mounting brackets.

￿

slide-assembly mounting-bracket flange

vertical rail

10-32 x 0.5-inch screws (2)

alignment marks

slide assemblies

(2)

IURQW￿RI￿UDFN

slide alignment screws

)LJXUH￿￿￿￿￿,QVWDOOLQJ￿WKH￿6OLGH￿$VVHPEOLHV

6.Install the slide assemblies in the rack.

NOTES: When installing the slide assemblies, be sure that the green plastic stops at the ends of the channels are at the back of the rack and that the green push buttons (on the interior slide) are near the front of the rack (see Figure 10).

If the slide assembly is completely extended and locked in position, press the spring located on the inside of the interior slide (near the end with the green plas- tic stop) to release the slide so that it can be returned to the retracted position.

Dell PowerEdge4x00 and 6x00 SystemsRack Installation Guide 9