Dell 540 manual Replacing the Media Card Reader

NOTICE: To comply with FCC regulations, it is recommended that you replace the drive panel insert whenever the FlexDock is removed from the computer.

1 back of the computer 2 drive panel insert (optional)

Replacing the Media Card Reader

1.Follow the procedures in Before You Begin.

2.Remove the computer cover (see Replacing the Computer Cover).

3.Remove the front panel (see Replacing the Front Panel).

4.Remove any expansion cards (see Replacing a PCI/PCI Express Card).

NOTICE: Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly routed or a disconnected cable could lead to computer problems.

5.Disconnect the cable that is connected to the mediacard reader from the system board (F_USB4).

6.Remove the screw that secures the Media Card Reader to the chassis.

7.Carefully remove the existing Media Card Reader from the computer.

1 screw 2 Media Card Reader

3Media Card Reader clamp

8.To install a new Media Card Reader, align and slide the Media Card Reader clamp into the Media Card Reader clamp slot.

9.Replace and tighten the screw that secures the Media Card Reader to the chassis.

10.Reconnect the cables to the system board.