Dell 6800 E07F0 Proc n Ierr, Proc n Thermtrip, Display this message until, System’s power cord is

Table 1-3. LCD Status Messages (continued)

Line 1	Line 2	Causes	Corrective Actions
Message	Message
E0780	PROC n PRESENCE	Microprocessor is not installed	Install a microprocessor in socket
		in socket n.	n. See "Installing a Processor"
			in your Installation
			and Troubleshooting Guide.
E07F0	PROC n IERR	Faulty or improperly installed	See "Troubleshooting the
		microprocessor.	Microprocessors" in your
			Installation and Troubleshooting
			Guide.
E07FA	PROC n THERMTRIP	Specified microprocessor is out	See "Troubleshooting System
		of acceptable temperature range	Cooling Problems" in your
		and has halted operation.	Installation and Troubleshooting
			Guide. If the problem persists,
			ensure that the microprocessor
			heat sinks are properly installed.
			See " Removing a Processor"
			in your Installation
			and Troubleshooting Guide.
			NOTE: The LCD continues to
			display this message until the
			system’s power cord is
			disconnected and reconnected to
			the AC power source, or the SEL is
			cleared using either Server
			Assistant or the BMC Management
			Utility. See the Dell OpenManage
			Baseboard Management
			Controller User’s Guide for
			information about these utilities.
E0876	PS n MISSING	No power available from the	See "Troubleshooting Power
	PS n STATUS	specified power supply; specified	Supplies" in your Installation
		power supply is improperly	and Troubleshooting Guide.
		installed or faulty.

E0876 PS n PREDICTIVE Power supply voltage is out of acceptable range; specified power supply is improperly installed or faulty.

See "Troubleshooting Power Supplies" in your Installation and Troubleshooting Guide.

E0876	PS n	AC	LOST	Power source for specified power	Check the AC power source
	PS n	AC	RANGE	supply is unavailable, or out	for the specified power supply.
				of acceptable range.

10

Information Update