Installing the Power-Switch Cable | Dell 7010 specification

4.Press in the retention clips and slide the power-switch cable out through the front of the computer.

Installing the Power-Switch Cable

1.Slide the power-switch cable in through the front of the computer.

2.Secure the power-switch cable to the chassis.

3.Thread the power-switch cable into the chassis clip.

4.Connect the power-switch cable to the system board.

5.Install the:

a)drive cage

b)front bezel

c)cover

6.Follow the procedures in After Working Inside Your Computer.

Removing the Input/Output (I/O) Panel

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

b)front bezel

c)drive cage

3.Disconnect and un-thread the I/O panel/ FlyWire cable from the fan-shelter clip and heat sink.

22

Image 22

Dell 7010 owner manual Installing the Power-Switch Cable, Removing the Input/Output I/O Panel

Contents

Regulatory Model D03S Regulatory Type D03S002 Dell Inc Contents Troubleshooting Your Computer System SetupDiagnostics Specifications Contacting Dell Working on Your Computer Before Working Inside Your Computer After Working Inside Your Computer Turning Off Your ComputerClick Shut Down Recommended Tools Removing and Installing ComponentsInstalling the Cover Removing the Cover Installing the Front Bezel Removing the Front Bezel Removing The Wireless Local Area Network Wlan Card Installing The Wlan Card Removing the Drive Cage Installing the Drive Cage Removing the Optical DrivePage Removing the Hard Drive Installing the Optical DrivePry the sides of the bracket to remove the optical drive Installing the Hard Drive Removing the Intrusion Switch Memory Module Guidelines Installing the Intrusion SwitchRemoving the Memory Installing the Memory Removing the Coin-Cell Battery Removing the System Fan Installing the Coin-Cell BatteryRemove Cover Front bezel Drive cage Page Installing the System Fan Removing the Speaker Installing the Speaker Removing the Power-Switch Cable Installing the Power-Switch Cable Removing the Input/Output I/O Panel Removing the Power Supply Installing the Input/Output I/O PanelRemove Cover Page Page Installing the Power Supply Lift the power supply out of the computer Removing the Heat Sink Page Installing the Heat Sink Removing the Processor Installing the Processor Removing the System BoardPage System Board Components Power connectorProcessor Installing the System Board Page Following table displays the system setup navigation keys System SetupBoot Sequence Navigation Keys System Setup Options Ahci Sata is configured for Ahci mode Disabled The Sata controllers are hiddenATA Sata is configured for ATA mode RAID on Sata is configured to support RAID mode OptionDescription Permitted when an administrator password is set They are set. This option is disabled by defaultPassword Change Is enabled and visible to the operating system All Enabled by default Reset All Keys- Resets to default settingKeys will restore to default settings Option is enabled by default Power loss. You can set the AC Recovery to Disabled by defaultAC Recovery Power Off default Keyboard Errors Signals. For Ultra Small Form Factor onlyIs enabled by default Sequence required to enter the Bios Boot Option Menu Serr Messages Software communicates. The default IP address isCommunicate. The default IP port is ImageServer IP System and Setup Password Updating the BiosJumper Settings Click Drivers & Downloads Assigning a System Password and Setup Password Computer Disabling a System Password Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Amber LED State White LED State Description Troubleshooting Your ComputerPower LED Diagnostics Possible system board resource and/or hardware failure Error Messages Beep Code Problem Error Message DescriptionFailure Configuration Information-please Run Setup program Invalid Memory System installed on it. Insert a bootable floppy disk Disk errorNot a boot diskette Value Memory size Write fault on Write faultSelected drive Page Specification SpecificationsFeature Feature Specification Discrete PCI Express x16 graphics adapter Express Chipset CPU-GPU ComboIntegrated Two Channel High Definition Audio Audio Front Panel Back Panel Form factor Mini-Tower and Desktop One 36-pin connectorPCI Express x1 data width maximum one PCI Express lane Front of the computer Power button light ConnectorWhite light indicates sleep state of the computer Power Wattage Maximum Heat Dissipation Voltage Physical Height Width Depth Weight Physical Height Width Depth Weight Ultra Small Form Factor 24.00 cm 30 kg 7.28 lb InchesPage Contacting Dell