Dell 7010 Installing the Input/Output I/O Panel, Removing the Power Supply, Remove Cover

4.Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to the right to release and remove from the computer.

Installing the Input/Output (I/O) Panel

1.Insert the I/O panel into the slot on the chassis front.

2.Slide the I/O panel towards the left of the computer to secure to the chassis.

3.Tighten the screw to secure the I/O panel to the chassis.

4.Connect the I/O panel/FlyWire cable to the system board.

5.Thread the I/O panel/ FlyWire cable into the fan-shelter clip and the routing on the heat sink.

6.Install the:

a)drive cage

b)front bezel

c)cover

7.Follow the procedures in After Working Inside Your Computer.

Removing the Power Supply

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

23