Installing The Power Supply
Lift the power supply out of the computer
Page
System Board
Removing The System Board
Installing The System Board
Follow the procedures in After Working Inside Your Computer
Page
Power Supply Unit PSU Thermal Sensor
Removing The PSU Thermal Sensor
Installing The PSU Thermal Sensor
Boot Menu
System Setup
System Setup
Boot Menu Enhancements
Timing Key Sequences
Navigation
Beep Codes and Text Error Messages
System Setup Options
Technology
SATA-2, SATA-3, and LOM MAC Address
System Configuration
Video
Security
Allow Non-Admin Password Changes This option is
Performance
Power Management
Protector or if Auto Power is set to disabled
Enable F12 Boot menu enabled by default
Post Behavior
Image Server
Maintenance
Virtualization Support
Address is
System Logs
Setting is
255.255.255.255
Displays the Bios Progress event log
Clear Log
Page
Diagnostic Light Patterns
Troubleshooting
Diagnostic LEDs
Power Button Problem
Power Button
Steps
Power Button Problem Description
LED
If the problem persists, the system board is faulty
Troubleshooting Steps Re-seat the processor
Troubleshooting Steps
Your computer
Possible expansion card failure has occurred
Beep Codes
Code1-1-2
Code Cause DMA page register read/write failure Through
Cause
Code Cause
Code
Cause Keyboard Controller Test failure Code
Code Cause Cache test failure
Error Messages
Address mark not found
Bad error-correction code ECC on disk read
Alert! Security override Jumper is installed
Bad command or file name
Data error
Decreasing available memory
Diskette subsystem reset failed
Hard-disk drive configuration error
Diskette drive 0 seek failure
Hard-disk drive controller failure
Invalid configuration information-please run Setup program
Invalid Memory configuration, please populate DIMM1
Hard-disk drive failure
Memory allocation error
Memory size in Cmos invalid
No timer tick interrupt
No boot device available
No boot sector on hard-disk drive
Non-system disk or disk error
Seek error
Read fault
Reset failed
Requested sector not found
Unexpected interrupt in protected mode
Time-of-day not set-please run the System Setup program
Timer chip counter 2 failed
Write fault
Write fault on selected drive
\ is not accessible. The device is not ready
Page
Processor
Specifications
Technical Specifications
Type
System Information
Audio
Network
Expansion Bus
PCI
External Connectors
Drives
Factor Back Panel Ultra Small Form Factor Front Panel Video
Connector
System Board Connectors
Vary based on the graphics card
Small Form Factor Ultra Small Form Factor
Controls and Lights
Turned on and is functional.
Power system by
System power supply
Outlet
Environmental
Power Wattage Maximum Voltage Heat Dissipation
Physical Height Width Depth Weight
S71.04-1985
Storage Grms Maximum shock Operating 40 G 105 G Altitude
Airborne contaminant level
102
Visit support.dell.com
Contacting Dell
Contacting Dell