Lift the power supply out of the computer
Installing The Power Supply
Page
Removing The System Board
System Board
Installing The System Board
Follow the procedures in After Working Inside Your Computer
Page
Removing The PSU Thermal Sensor
Power Supply Unit PSU Thermal Sensor
Installing The PSU Thermal Sensor
System Setup
System Setup
Boot Menu
Boot Menu Enhancements
Timing Key Sequences
Beep Codes and Text Error Messages
System Setup Options
Navigation
SATA-2, SATA-3, and LOM MAC Address
Technology
System Configuration
Security
Video
Allow Non-Admin Password Changes This option is
Performance
Protector or if Auto Power is set to disabled
Power Management
Post Behavior
Enable F12 Boot menu enabled by default
Virtualization Support
Maintenance
Image Server
Address is
Setting is
255.255.255.255
System Logs
Clear Log
Displays the Bios Progress event log
Page
Diagnostic LEDs
Troubleshooting
Diagnostic Light Patterns
Power Button Problem
Steps
Power Button
Power Button Problem Description
LED
Troubleshooting Steps Re-seat the processor
If the problem persists, the system board is faulty
Troubleshooting Steps
Possible expansion card failure has occurred
Your computer
Code1-1-2
Beep Codes
Code Cause
Cause
Code Cause DMA page register read/write failure Through
Code
Cause Keyboard Controller Test failure Code
Error Messages
Address mark not found
Code Cause Cache test failure
Bad command or file name
Alert! Security override Jumper is installed
Bad error-correction code ECC on disk read
Data error
Hard-disk drive configuration error
Diskette subsystem reset failed
Decreasing available memory
Diskette drive 0 seek failure
Invalid Memory configuration, please populate DIMM1
Invalid configuration information-please run Setup program
Hard-disk drive controller failure
Hard-disk drive failure
Memory size in Cmos invalid
Memory allocation error
No boot sector on hard-disk drive
No boot device available
No timer tick interrupt
Non-system disk or disk error
Reset failed
Read fault
Seek error
Requested sector not found
Timer chip counter 2 failed
Time-of-day not set-please run the System Setup program
Unexpected interrupt in protected mode
Write fault
\ is not accessible. The device is not ready
Write fault on selected drive
Page
Technical Specifications
Specifications
Processor
Type
Network
Audio
System Information
Expansion Bus
PCI
Drives
External Connectors
System Board Connectors
Connector
Factor Back Panel Ultra Small Form Factor Front Panel Video
Vary based on the graphics card
Small Form Factor Ultra Small Form Factor
Controls and Lights
System power supply
Power system by
Turned on and is functional.
Outlet
Power Wattage Maximum Voltage Heat Dissipation
Physical Height Width Depth Weight
Environmental
Airborne contaminant level
Storage Grms Maximum shock Operating 40 G 105 G Altitude
S71.04-1985
102
Contacting Dell
Contacting Dell
Visit support.dell.com