Back to Removing and Replacing Parts
IEEE 1394 Port
Dell™ Latitude™ E6410/E6410 ATG Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the IEEE 1394 Port
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3.Remove the battery.
4.Remove the SIM card.
5.Remove the SD card.
6.Remove the ExpressCard.
7.Remove the Smart card.
8.Remove the hinge covers.
9.Remove the access panel.
10.Remove the optical drive.
11.Remove the hard drive.
12.Remove the LED cover.
13.Remove the keyboard.
14.Remove the
15.Remove the memory.
16.Remove the WWAN card.
17.Remove the WLAN card.
18.Remove the Latitude On™ Flash/CMG module.
19.Remove the Fingerprint Reader.
20.Remove the Heat Sink and Processor Fan.
21.Remove the Display Assembly.
22.Peel back the Ferrite sheet covering the firewire cable.
23.Disconnect and unthread the firewire data cable from the system board.
24.Remove the screws that secure the IEEE 1394 board to the computer.
25.Remove the IEEE 1394 board from the computer.
Replacing the IEEE 1394 Port
To replace the IEEE 1394 port, perform the above steps in reverse order.
Back to Removing and Replacing Parts
